DeNiro Volare show jumping boots (configurator)

VIBRAM: Our handmade sole consists of two layers of leather and a rubber Vibram non-slip soles. These three layers are double-frame sewn.

The insole with activated carbon is shock-absorbing and has a natural antibacterial function.

Ride & Fly: Thanks to its molecular nanotech particles, this sole is non-toxic, recyclable, antibacterial, shock-absorbing, shock-absorbing, water- and fire-resistant, anti-traumatic and extremely light.

the color of the piping can be written at "Annotation to your order"

Here you can choose the color of the just selected parts and tops (surcharge). In the last step, there is an annotation box where you can assign the colors to the places.

Can only be chosen, if you have added punched holes at the toe cap or at the top etc. (surcharge)

Please enter your comments on the order (which color where, which stitch color or special wishes).

Here you can upload pictures that we need for your order.

Please look at the video and check if you need a part measurement. The measurement table is on the next side.

Please click on picture to enlarge. The first value in the table is the height at the backstrap without heel, the second value is the calf amount/circumference with breeches and socks.

DeNiro boots drop 1cm in use due to the narrow cut in the ankle, please open this to the measured height from the floor to the hollow of the knee when standing. Please do not take the height from old boots from other manufacturers, they measure the height differently, otherwise the new boot would be much too high. If you already have a boot that fits the height, you can pull it out by the back strap without a heel and measure it. This corresponds to the ordered DeNiro height.

The standard circumference at the end of the shaft is calf circumference - 2cm. With a 38 calf, the shaft end would be 36 cm, please check it, otherwise the boot will stick out at the top! If the value is smaller, please order a custom-made product. Please take the calf -1,5cm for a very tight fit at this model!

If you only need to change a little part of the shaft, you can add a shaft part measurement.

In order to ensure an optimal fit, DeNiro boots are recommended to be fully made to measure. However, it is also possible to customize only the shaft of the DeNiro boots. You can specify the values ​​in the next step.

In order to ensure an optimal fit, DeNiro boots are recommended to be fully made to measure.

Please write down your body height in cm in the field below, this will help us to see if you pick the right shaft height.

Now that you have entered all the required values for this boot, the "Apply configuration" button appears below. Please do not forget to put the boot in the shopping cart afterwards.