Kngsley Aspen riding boots (configurator)

Bitte Bild anklicken zum Vergrößern. Der erste Wert in der Tabelle ist die Höhe am Hinterriemen ohne Absatz, der zweite Wert der Wadenumfang mit Reithosen und Socken. Bitte nehmen Sie den Stiefel maximal 0,5cm enger, als im Wadenumfang gemesen, der Elastik fällt normal aus. Bei der Höhe können Sie 1,5cm für das Setzen addieren.

Attention: The shoe size is small, please choose one size bigger!

Kingsley boots stretch by 1cm in use due to the narrow cut in the ankle, but they are generally 0.5cm shorter. So please add 1.5cm to the measured height from the floor to the back of your knees when standing. Please do not take the height from old boots from other manufacturers, they measure the height differently, otherwise the new boot would be much too high. If you already have a boot that fits the height, you can pull it out by the back strap without a heel and measure it. This corresponds to the ordered Kingsley height -0.5 cm.

Warning: the model is normal despite the elastic, please order a maximum of 0.5 cm tighter. Please do not take the calf circumference from your old boot! This may have a different elastic insert and has stretched more.

This is included free of charge with Kingsley and should always be specified. With breeches and socks on, please measure the narrowest part above the ankle with a normal fit.

Kingsley boots are 0.5 cm shorter in height (measured on the back strap without a heel). If you want the height to be slightly higher than the table dimension, you can select this here. If you want to adjust the circumference of the shaft end (so that the boot does not protrude at the top), this can also be done with the surcharge for the height section. (Height +0cm). This will be specified in the next step.

This can only be specified if you have selected the surcharge for a small partial dimension for the height!

The standard circumference at the end of the shaft is calf circumference - 2cm. With a 38 calf, the shaft end would be 36 cm, please check it, otherwise the boot will stick out at the top! If the value is smaller, please order a custom-made product.

If you have not found a suitable calf measurement in the measurement table, you can change it here by up to 1.5 cm. The elastic insert on Kingsley yields 0.5cm during use.

A full measure is possible even with the entry-level models at Kingsley. So if you don't get along with the table dimensions, a full dimension is also possible here. Please refer to the notes regarding height and calf in the previous steps.

Diese können nur ausgefüllt werden, wenn Sie den Aufpreis für das Vollmaß angeklickt haben. (siehe unten):

Here we need the surcharges that the Kingsley configurator has shown you, so that we do not have any additional requests after the order. You should now see the correct total price.

Please write down your body height in cm in the field below, this will help us to see if you pick the right shaft height.

Now that you have entered all the required values for this boot, the "Apply configuration" button appears below. Please do not forget to put the boot in the shopping cart afterwards.

Please enter your comments on the order (which color where, which stitch color or special wishes).