Cavallo Insignis dressage boot (configurator)

Achtung: Großes Logo nicht in Verbindung mit dem Rand am Insignis Bogen möglich. Nur, wenn der Rand weggelassen wird, ist das große Logo möglich.

The color of the border / cuff depends on the leather color of the boot.

Please write down any comments on your order (which color where or special wishes).

Here you can upload pictures that we need for your order.

Please look at the video and check if you need a part measurement. The measurement table is on the next side.

Attention: Cavallo boots are 2cm shorter (measured on the back strap without heel) and drop around 1-2cm in use. So please order at least a 3cm higher shaft height than measured from the ground to the hollow of the knee (when standing).

Please click to enlarge the measurement table.

Depending on the model, Cavallo offers up to 7 different lasts. Typically, most stores use only the normal last, which is far too wide for most customers. That's why we offer you the option of having your boots adjusted even better in your foot, and at no extra cost. For this we need your heel- instep- and ball amount, which you please enter in the fields below. We will then find the right last for you.

For boots with zipper on the back or polo models, Cavallo offers the possibility to cut also standard boots without extra price tight in the under calf area. For this there are the so-called ABC dimensions. The circumference 25cm above the ground, 20cm above the ground and 15cm above the ground. Please enter these dimensions in the box below. This dimension is also without surcharge.

Here you can enter the desired shaft height. Please look carefully, if your values ​​can still be found in the size chart in combination with the shoe size. If you need other dimensions, you can order a custom made boot in the next steps. Attention: Cavallo boots are 2cm shorter (measured on the back strap without heel) and drop around 1-2cm in use. So please order at least a 3cm higher shaft height than measured from the ground to the hollow of the knee (when standing).

The little part measurement makes sense with small differences regarding to the measurement table. The standard circumference in the bootleg end amount is calf circumference - 2cm. For a 38cm calf, the bootleg end would be 36cm, please check if 2 fingers would fit into the tape measure, otherwise it may happen that the bootleg end is too wide or too tight.

Write down your measurements if you have chosen the extra price for shaft part measurement. If you have different sizes on the left or right leg please write down: (left/right).

The foot part measurement is useful at very high instep or heel circumference, or very narrow feet. If you are not sure if you need it, please ask us first.

Write down your measurements if you have chosen the extra price for full measurement. If you have different sizes on the left or right leg please write down: (left/right).

Please write down your body height in cm in the field below, this will help us to see if you pick the right shaft height.

Now that you have entered all the required values for this boot, the "Apply configuration" button appears below. Please do not forget to put the boot in the shopping cart afterwards.